[cpurage]

Thanks a ton pazi88 and yes I already used the 202305_InternalFlash.bin file from the GitHub repository and flashed it with the STM32CubeProgrammer in advance before flashing the Visual Studio code on top of the 202305_InternalFlash.bin … thanks I’ve found the Generic base tune and will give it a try later today once I’m next to my (your creation and design for which I’m very thankful) V4 hardware and will be very glad if I successfully implement it in my IS300 SportCross

[darkoe97]

Hello, i have a audi a3 1.8t agu engine, 1997 year. I want to ask what jumper on the board is so i can switch the hall sensor from 3.3v to 5v, or 5v to 3.3v.
Thank you

[dazq]

Hello, i have a audi a3 1.8t agu engine, 1997 year. I want to ask what jumper on the board is so i can switch the hall sensor from 3.3v to 5v, or 5v to 3.3v.
Thank you

Which speeduino board are you using?

[darkoe97]

V0.5.3
Stm32_f4ve

[joe94350]

Bonjour, j'ai un problème avec la planche STM32 Pazi88. Je charge le firmware sans soucis je me connecte mais je n'ai pas de pompe à essence ni signal crank et came... Avec firmware 2023.11 dev 2023.10 2023.05.
Le seul qui fonctionne es le 202207.1
Auriez vous une solution à ce soucis ? J'ai essayé sur d'autres planche Black Stm32f407 et j'ai le même soucis. Merci

[brindoro]

from youtube by pazi88:

Some time ago I did design this Arduino Mega replacement board for Speeduino ECU that uses STM32F407 processor. With this processor board you can have all the modern features that Speeduino offers, on your old speeduino ECU just by swapping out the processor card.

My GitHub page for this board: https://github.com/pazi88/STM32_mega
PCBWay to order boards: https://www.pcbway.com/
STM32Cube Programmer: https://www.st.com/en/development-too...
My GitHub page for the BMW PnP boards: https://github.com/pazi88/Speeduino-M...
Speeduino Page: https://speeduino.com/home/

Has someone posted instructions on how to actually order these boards from PCBWAY. I can solder, not sure I can figure out pcbway... Help appreciated!

[JB21]

Hi guys,

I am currently playing around with a STM32F407VG06 Firmware.

After clicking verify to compile it, I get the attached Error- what am I doing wrong?

Thanks!

[jonbill]

I'd imagine fastcrc is a library from elsewhere, and you haven't yet got it installed.

[JB21]

I thought that also, but how do I get that package?

[jonbill]

Looking a bit closer, the package is included in the speeduino source, so I think the problem may be how its referenced in globals.h.
It is included as "src/fastCRC/FastCRC.h", which is a relative path, so you have to be running the compiler from the Speeduino directory.
Which IDE are you using? Is this the arduino IDE or platformio?