Speeduino

Greetings, I was wondering if the speeduino supports 2 CAM sensors, I have a 350Z and was looking into building/buying a unit but couldn't confirm if It's supported. There are also 4 O2 sensors (2up and 2dn), does it support 2 widebands as well?

VQ35DE

Thanx
Wink

Not at this time. Had the same issue with my Honda GW 1200 '85 FI Model. Two cam sensors for fuel injector firing.

wink1212 wrote: ↑Wed Jan 15, 2025 3:34 pm Greetings, I was wondering if the speeduino supports 2 CAM sensors, I have a 350Z and was looking into building/buying a unit but couldn't confirm if It's supported. There are also 4 O2 sensors (2up and 2dn), does it support 2 widebands as well?

VQ35DE

Thanx
Wink

The firmware does support two O2 sensors but the second input is only for logging and monitoring purposes it can operate any closed loop control.

The second cam input support is very limited and is still in its infancy so should be considered not for general use.

I am heading down a similar path.

I am converting a VQ35DE out of a Maxima (FWD 4 door)

My understanding is Speeduino does not have a trigger for the VQ crank/cam triggers. I have modified the flex plate to give me a 36-1 pattern. I have not tested it yet, as the gearbox has to come out again. And I still have to do some wring.

Good Luck

Thanx for all the input. I'm still in the pre-planning stages so I'm just tryna get as much info as possible.