- Wed Dec 25, 2024 9:18 pm
#70320
Hello,
I design my first speeduino board with an STMF411 MCU. Currently I testing the HW moduls with simulation (crankshaft simulation, voltage etc.)
MAP, IAT, CLT, TPS and O2 sensors is work propely. The injector and igniton outputs is work fine in HW test mode. (PWM is ok on the oscilloscope)
I simulate the cranking signals. Tunerstudio show the cranking and runing mode so looks like ok, but I only measure the igniton pwm, the injection is not working.
What am I doing wrong?
I design my first speeduino board with an STMF411 MCU. Currently I testing the HW moduls with simulation (crankshaft simulation, voltage etc.)
MAP, IAT, CLT, TPS and O2 sensors is work propely. The injector and igniton outputs is work fine in HW test mode. (PWM is ok on the oscilloscope)
I simulate the cranking signals. Tunerstudio show the cranking and runing mode so looks like ok, but I only measure the igniton pwm, the injection is not working.
What am I doing wrong?
