- Sat May 25, 2024 4:49 pm
#68460
Hello,
Just received my UA4C vC5 board and while testing it (Nothing wired yet... just 12V from a PSU and USB to laptop) I noticed my MAP and BARO sensors are not working correctly. In Tunerstudio they go all the way to 200kPa for MAP and 120kPA for Baro. I can suck/blow on the little included tube for the MAP and there is no movement. Sensors has been correctly selected in Tunerstudio and "Burned". BARO sensor pin was set to A7 because that is what the schematic PDF says...
Fooling around I applied a 0-5V voltage from a variable PSU to the TPS wire just to see if TunerStudio would show "movement" in the dial and to my surprise... actually the MAP reading went to 0kPA when applying 0V and moved depending on the applied voltage to the TSP pin!!!
I'm just starting to learn about speeduino and from my understanding... I am not using the correct reference file when creating a new project in TunerStudio. I got my reference file downloaded from SpeedyLoader while flashing the ArduinoMega board. Is this the correct file to use or should a specific reference file for the UA4C board and its specific pins be used?
Already looked in the hardware wiki and couldn't find an .ini file on the 4UAC vC5 WhiteFang directories....
Anyone know what I might be doing wrong?
Just received my UA4C vC5 board and while testing it (Nothing wired yet... just 12V from a PSU and USB to laptop) I noticed my MAP and BARO sensors are not working correctly. In Tunerstudio they go all the way to 200kPa for MAP and 120kPA for Baro. I can suck/blow on the little included tube for the MAP and there is no movement. Sensors has been correctly selected in Tunerstudio and "Burned". BARO sensor pin was set to A7 because that is what the schematic PDF says...
Fooling around I applied a 0-5V voltage from a variable PSU to the TPS wire just to see if TunerStudio would show "movement" in the dial and to my surprise... actually the MAP reading went to 0kPA when applying 0V and moved depending on the applied voltage to the TSP pin!!!
I'm just starting to learn about speeduino and from my understanding... I am not using the correct reference file when creating a new project in TunerStudio. I got my reference file downloaded from SpeedyLoader while flashing the ArduinoMega board. Is this the correct file to use or should a specific reference file for the UA4C board and its specific pins be used?
Already looked in the hardware wiki and couldn't find an .ini file on the 4UAC vC5 WhiteFang directories....
Anyone know what I might be doing wrong?