- Sat Mar 02, 2024 8:34 pm
#67369
im setting up a b18c1 in a 1990 crx for a friend of mine. i built a v0.4 board and im using it in conjuction with the ss-obd1 adapter from wtmtronics.
My friend purchased an additional distributor off ebay for me to modify the crank/cam trigger wheels but this is seeming to be difficult to properly setup since the crank and cam are both 1/2 of crank speed.
Im considering cutting 2 teeth off on the 24t wheel to turn it into two 12-1 wheels for the crankshaft sensor input, and using poll level on the "snail" single tooth.
Any other suggestions on this?
My friend purchased an additional distributor off ebay for me to modify the crank/cam trigger wheels but this is seeming to be difficult to properly setup since the crank and cam are both 1/2 of crank speed.
Im considering cutting 2 teeth off on the 24t wheel to turn it into two 12-1 wheels for the crankshaft sensor input, and using poll level on the "snail" single tooth.
Any other suggestions on this?