Any general discussion around the firmware, what is does, how it does it etc.
By rogelioamick
#66999
Hi guys,
I have a 86 325i e30, that I converted to Speeduino, the car ran for one year now, when suddenly it wont start anymore and does not get any spark, I swap the coil, the cps sensor, the relays and nothing seams to halp. I quickly went over tha wiring, nothing seams out of the ordinary. Now I started to check the speeduino, and noticed that the LEDs for the Ignition drivers don't come on when I'm cranking the car, I assume that the the ignition drivers would be at fault, is there any way to say for sure.
If anybody knows anything about this please let me know. Thanks
Injected 2 stroke Bultaco

Alternator testing. Its a 3 phase circa 200w alter[…]

BMW E23 M30B28

Okay, I managed to start the engine. The &quot[…]

NO2C crank signal issues

Once again PSIG, thank you. Note this is set up fo[…]

I've managed to dig up a few obscure wiring diag[…]

Still can't find what you're looking for?