- Fri Jan 26, 2024 8:31 am
#66847
Hello.
Lately I have noticed a lot of talk about these options and whether they should be enabled or not..
So I am wondering if I should enable any of the given options under VE table and if they are any good or not, assuming I am using latest firmware to date. And If there are some additional options that need to be configured if using these? Like AFR protection operation ranges or something else ?
Multiply VE value by MAP ratio
Multiply VE by ratio of AFR to Target AFR
Multiply by ratio of stoich AFR/target AFR (incorporate AFR)
Bare in mind that I am not fully understanding what these options are doing from two sentences under help icon or wiki..
At the moment I have not enabled them, since once I tried and wbo2 failed, got so rich fueling that engine could not rev past 4.9k rpm ... so I disabled them and retuned VE table to avoid this happening again..
Lately I have noticed a lot of talk about these options and whether they should be enabled or not..
So I am wondering if I should enable any of the given options under VE table and if they are any good or not, assuming I am using latest firmware to date. And If there are some additional options that need to be configured if using these? Like AFR protection operation ranges or something else ?
Multiply VE value by MAP ratio
Multiply VE by ratio of AFR to Target AFR
Multiply by ratio of stoich AFR/target AFR (incorporate AFR)
Bare in mind that I am not fully understanding what these options are doing from two sentences under help icon or wiki..
At the moment I have not enabled them, since once I tried and wbo2 failed, got so rich fueling that engine could not rev past 4.9k rpm ... so I disabled them and retuned VE table to avoid this happening again..