- Sat Dec 30, 2023 3:42 pm
#66495
Just connected my Teensy based unit for the first time, went through all the settings and connected it to tuner studio and all looked good (DVJCODEL TEENSY rev B, running 202012 firmware) this on the bench not connected to the engine yet. I did an update to 202310 firmware and now my map is all over the place, the needle goes up and down the gauge all the time, never stops moving. have I messed up? i tried to download a video but it says there's an error, sorry. Any help would be much appreciated.
- By MarcoRosi
- By PSIG