- Fri Dec 08, 2023 3:34 am
#66170
Hello all,
I would like to build the speeduino Dropbear ECU but getting the T3.5 is quite a challenge and i would like to use the T4.1 but will it drop in.
I have watched Joshes youtube video and it looks like he placed the teensy one pin forward.
If i can get some confirmation that it will work i will go ahead and get everything.
Im building a Naturally Aspirated Mini A motor 1275cc with the K1200RS head so i need an ECU and the Dropbear looks good.
i would like to turbo it at a later time and this should allow it without a new ECU.
also i have the Kicad Dropbear V1.1 PCB i plan on printed and building is this current as well?
any help would be greatly appreciated.
I would like to build the speeduino Dropbear ECU but getting the T3.5 is quite a challenge and i would like to use the T4.1 but will it drop in.
I have watched Joshes youtube video and it looks like he placed the teensy one pin forward.
If i can get some confirmation that it will work i will go ahead and get everything.
Im building a Naturally Aspirated Mini A motor 1275cc with the K1200RS head so i need an ECU and the Dropbear looks good.
i would like to turbo it at a later time and this should allow it without a new ECU.
also i have the Kicad Dropbear V1.1 PCB i plan on printed and building is this current as well?
any help would be greatly appreciated.
Attachments
Untitled.png (1.48 MiB) Viewed 2652 times
Current Build:
Mini Clubman 1275 with a K1200RS Head.
ECU: Dropbear T4.1 (Hopefully)
Mini Clubman 1275 with a K1200RS Head.
ECU: Dropbear T4.1 (Hopefully)