[Justin G]

Hey all, just received my speeduino 0.4.3 kit the other day and started to assemble it, and I have a question about the correct orientation to install the MAP sensor that's probably a little bit naive. The board says "flat side up" which had me initially bend the pins so that the flat side, that I would normally consider the bottom, is up. I've seen this orientation on a couple of pictures of assembled boards but it took a lot of searching. The majority of builds have the notched face upwards, which makes more sense to me, and I was talking to someone who recently assembled their own and they also installed theirs with the notched side up. Which is the actual correct orientation for the MAP sensor?