Any general discussion around the firmware, what is does, how it does it etc.
#63897
I was working on a ford engine with an uneven 4 tooth cam trigger, I was able to isolate 1 tooth out of the pattern and use that as a sync for sequential operation on that engine.
the way i did it was using the crank trigger teeth, i had a 36-1 crank trigger, I added code if it saw a cam tooth between crank tooth between 13-16 to use that cam tooth as sync.
But I'm not a coder either so may not be the best solution.
#65029
Development is done in theory. Just don't done final testing to see if we can make the vvt readout more logical. Once we've got the test results (hopefully this week) we'll either be done & can start on road testing or I need to make a little tweak.
#65985
miker wrote: Tue Sep 26, 2023 1:45 pm Development is done in theory. Just don't done final testing to see if we can make the vvt readout more logical. Once we've got the test results (hopefully this week) we'll either be done & can start on road testing or I need to make a little tweak.
@miker could you please upload your code to a branch on github or if you're using a different repo could you please point me to it? I'm a developer also (have never contributed to Speeduino), just starting on a J series Honda project and would love to be able to use or crib off of your work if possible. Thank you!!
Can bus problem with STM32

I placed a 120 ohm resistor on the speeduino side […]

How bad did I mess up my PCB

It's probably recoverable. Take a look at the sche[…]

Suzuki RE-5 EFI Conversion

check the relay is clicking, and the fuse. Check t[…]

That’s awesome! Congrats! So you were still[…]

Still can't find what you're looking for?