Any general discussion around the firmware, what is does, how it does it etc.
User avatar
By gPortilla
#62106
Hello everyone.
I'm trying to compile Speeduino code on an Arduino Portenta H7.
The Arduino Portenta H7 is based on the STM32H747 microcontroller, XI series. (STM32H747XI dual Cortex®-M7+M4 32bit low power Arm® MCU) some more information:
H7's main processor is the dual core STM32H747 including a Cortex® M7 running at 480 MHz and a Cortex® M4 running at 240 MHz. The two cores communicate via a Remote Procedure Call mechanism that allows calling functions on the other processor seamlessly.
https://store.arduino.cc/products/portenta-h7#
Image

In the globals.h file of the speeduino program code there are the definitions for the different boards.
Is it possible for the program code to work on this board? :idea: :idea:

I uploaded logs and last tune and dyno plots look[…]

you could set 'skip revolutions' to 3, then it wou[…]

Hi, I am trying to assign Signed values to the x-a[…]

blitzbox

I've finally figured out why MAP and Lambda weren'[…]

Still can't find what you're looking for?