- Tue Apr 12, 2022 4:58 am
#56447
20220412_164244.jpg (2.87 MiB) Viewed 2524 times
20220412_164054.jpg (4.48 MiB) Viewed 2524 times
20220412_163933.jpg (4.65 MiB) Viewed 2524 times
20220412_152659.jpg (3.04 MiB) Viewed 2524 times
20220412_152520.jpg (3.59 MiB) Viewed 2524 times
Okay long one here.
Just received my m50 PnP. Plugged it into my PC and all was fine, verified it has a basemap on it, wicked.
Plugged it into my car and laptop and fired it up, ran a little rough but to be expected. Shut the car off and calibrated my TPS. The second I did that the ecu basically bricked itself. Nothing works anymore, tunerstudio gets nothing but constant errors. Both the laptop and PC can see it in device manager just fine but tunerstudio can't do anything. The car still cranks over but won't start anymore. Put the original ecu in and the car is back to normal. I can't reinstall the firmware onto the ecu as it just gets an stk500v2 error and times out. Times out if I try running anything in arduino IDE. No clue what's going on with it. Any help would be great
Just received my m50 PnP. Plugged it into my PC and all was fine, verified it has a basemap on it, wicked.
Plugged it into my car and laptop and fired it up, ran a little rough but to be expected. Shut the car off and calibrated my TPS. The second I did that the ecu basically bricked itself. Nothing works anymore, tunerstudio gets nothing but constant errors. Both the laptop and PC can see it in device manager just fine but tunerstudio can't do anything. The car still cranks over but won't start anymore. Put the original ecu in and the car is back to normal. I can't reinstall the firmware onto the ecu as it just gets an stk500v2 error and times out. Times out if I try running anything in arduino IDE. No clue what's going on with it. Any help would be great
- By Svetoslav
- By PSIG