For anything related to the 'official' Speeduino boards (Eg v0.3, v0.4 etc)
Remove one tooth. ie make it a missing tooth. that would make it a 24-1

originally a 24 tooth wheel - 1 missing.

ASSUMING it is at cam speed. And make sure your trigger is set at cam speed if you perform this modification

On my toyota V6 when I built it (3 years ago) i went through all this. Same tune as then. I run a 24 tooth dizzy, modified to be 2 x (12-1) ie 11 teeth, one missing, 11 teeth, one missing. But set at crank speed. you cannot run sequential at this setting. At the time it was the best I found.

Have fun
Well I replaced the Arduino board which seems to have solved my main issue. Can't get the engine fired up yet but check out the scope readings from last night! Looking good.

Blue = Ignition output
Green = Injector #6
Purple = Crank
Yellow = Cam
IMG_20220628_212343.jpg (3.12 MiB) Viewed 3349 times
I just wanted to make a post to tie this all up.

I ended up having two separate issues:

1: Somehow the Arduino board was damaged causing the injectors and ignition to fire sporadically. Replacing just the Arduino solved that problem.

2: The spark plugs were so fouled from failed starting attempts that the timing light wouldn't fire. I've never seen that one before lol.

I've switched from a distributor to a coil pack and swapped in some new plugs and the van is FINALLY RUNNING.

Ive made my own alternator controller and now it's time to get the fuel table dialed in. Thanks for all the help. I've learned more from this one car than I have with any other car I've tuned.

This is the IACV wires

i did the change, warmup still does not have any m[…]

J35a4 Triggers

Do you mean something simular to this, when you sa[…]

944 tuning and troubleshooting

I haven't tested more recent production samples […]

Still can't find what you're looking for?