- Sun Oct 10, 2021 8:50 pm
#53538
I liked the case that the dropbear uses so I designed this ecu which uses the Mega2560 and is compatible with 0.4 pin designations in TS and compatible with the dropbear connector pinout.
Being basically a 4cyl design it’s connector can use the extra 4 ign pins to reinstate the 4 outputs that are lost when using stepper on the dropbear. (Jumper selectable to allow full dropbear pinout compatibility if wanted, with 8 paired inj outputs and 8 waste spark ign outputs).
Being basically a 4cyl design it’s connector can use the extra 4 ign pins to reinstate the 4 outputs that are lost when using stepper on the dropbear. (Jumper selectable to allow full dropbear pinout compatibility if wanted, with 8 paired inj outputs and 8 waste spark ign outputs).
Attachments
26531C84-F5B7-421B-8487-21B5361C655B.jpeg (691.38 KiB) Viewed 9560 times