Speeduino

Dear all,

i assembled a 0.3.7 board and tried the hardware test.
injection is ok but on the ignition only 1 channel is working.
inspected the board and looked in the schematics,and other then a resistor difference in BOM/schematics (160ohms in stead of 10 ohms) i couldn't find the problem in the board itself.
Started checking the clone mega, and found that the pinout is different from the schematics.

schematics pinout for ignition:
24,28,36 and 40.
actual pinout on mega:
38,40,50,52.

now is my question, do i need a earlier firmware?or can i adjust the pins in the settings?

thanks in advance.
Jan

Please post your tune...

The pinout hasn't changed on the 0.3 board as it hasn't had any development for a couple of years.

You are doing something wrong.

It appears you have the wrong board selected in TunerStudio. Default setting is v0.4-series (output on 38-40-50-52), and yours is v0.3-series.

Go to Settings > Engine Constants > Board Layout.

at PSIG.

Thanks for he tip.
That was the problem, now it works .

Jan