- Sun Nov 29, 2020 4:12 pm
#46769
- It seems the most unnesesary option is stepper controller which take 4 wires.
- 4 injector and 4 ignition IGBTs possible remain and schematic to have one universal board
and place 1,2,3 or 4 channels
- I want place on board contactless magnetic TPS
- IAT as well could be on PCB
joey120373 wrote: ↑Sun Nov 29, 2020 2:04 pm The current board has most of the features of a standard speeduino board, 4 injector drivers, stepper controller etc, plus it also has 4 ignition IGBTs on board because 3 of my projects do not have a separate ignition module.Hi Joe. Your project look nice and seems very good starting point.
So, that being the case, it could be made much smaller by getting rid of a lot of that stuff.
- It seems the most unnesesary option is stepper controller which take 4 wires.
- 4 injector and 4 ignition IGBTs possible remain and schematic to have one universal board
and place 1,2,3 or 4 channels
- I want place on board contactless magnetic TPS
- IAT as well could be on PCB