Second firmware live stream happening this weekend: viewtopic.php?f=13&t=3992
For discussion of Speeduino compatible boards designed / built by other members of the forum and for guidance around making such a board
By joey120373
I have a project I started a few years back, I had intended to use a Micro-Squirt Module, on a custom PNP board, for my motorcycle. Its a KTM Superduke 990.

I designed and built the PNP board, it has the coil IGBTs, as well as an arduino pro mini to control a secondary Stepper motor ( secondary throttle plates ) as well as interface with safety sensors like the kick stand and clutch inputs.

Unfortunately the MicroSquirt died, and I couldnt get the supplier to even try to fix it , the motorolla Micro just quit and I simply couldn't bring myself to fork over ~$300 for a new one. so the project got thrown in a drawer.

So i thought, why not just build my own with Speeduino?
So this a pin compatable, same form factor board, with Extra JST headers for the extra 2 injectors, 2 coil outs and IAC.

Just saw I spelled " SPURT" wrong on the silk screen.
Speeduino_MicroSquirt_module_back.png (121.12 KiB) Viewed 231 times
Speeduino_MicroSquirt_module_front.jpg (276.65 KiB) Viewed 231 times
User avatar
By Mr_Hypnotic
Very cool! Too bad about the MS. I guess it wasn't meant to be.

Are you going to order it as a bare board or a completed assembly?
By joey120373
Plan on just a bare board, I haven’t tried using the assembly service, and haven’t tried sourcing parts from their ( JLB ) inventory. I might have to try it though.

I’ll probably order the boards tonight, just triple checking everything and making small changes hear and there .

From digging around, I think I found my issue... P[…]

I fixed the timing problem, it has no jitter now. […]

New 202005 firmware

is it possible there's something particular in you[…]

Yes although a simple trigger for fuel only will s[…]

Still can't find what you're looking for?