New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Help with building your Speeduino, installing it, getting it to run etc.
By hello
#40938
Hi;
Will tunerstudio lite 3.1.01 program a V0.4? I was able to compile ini file but program locks up when
choose settings
engine constants

And is there a selection for a hall sensor wheel that is solid with a opening in a portion of it?
Thanks
#40949
I've looked at those,
thanks for reply
for others to know so threads don't repeat its a bmw k100, the stock has two hall sensor 180 apart with one hole in the trigger wheel. Each time it comes to the hole it will spark, one for cyl 1&4 the other for 2&3. in wasted spark config.
I've upgraded the original coils, the stock drew 0.5A which I changed to ford which drew 1.7A, now I tried to COP 2+A and destroyed the original igniter. It may start for a minute or two then dies. A very robust system for the time.

The distributor selection seems the best, but it needs to spark half way in between as well and I don't know the selections in tunerstudio for this. If you can help please let me know.

watch out the snake is goin to bit ya

I've been chasing a hard starting issue on my car […]

data logging

Will the engine continue to run? Are you using tu[…]

The teensy adaptor boards have supplementary pin i[…]

Rpm Signal Dropout

With my 60-2 and VR sensor i don't use a capacitor[…]

Still can't find what you're looking for?