New wiki and manual has launched! Check it out at http://wiki.speeduino.com
Help with building your Speeduino, installing it, getting it to run etc.
By hello
#40938
Hi;
Will tunerstudio lite 3.1.01 program a V0.4? I was able to compile ini file but program locks up when
choose settings
engine constants

And is there a selection for a hall sensor wheel that is solid with a opening in a portion of it?
Thanks
#40949
I've looked at those,
thanks for reply
for others to know so threads don't repeat its a bmw k100, the stock has two hall sensor 180 apart with one hole in the trigger wheel. Each time it comes to the hole it will spark, one for cyl 1&4 the other for 2&3. in wasted spark config.
I've upgraded the original coils, the stock drew 0.5A which I changed to ford which drew 1.7A, now I tried to COP 2+A and destroyed the original igniter. It may start for a minute or two then dies. A very robust system for the time.

The distributor selection seems the best, but it needs to spark half way in between as well and I don't know the selections in tunerstudio for this. If you can help please let me know.

watch out the snake is goin to bit ya
data logging

Will the engine continue to run? Are you using tu[…]

The teensy adaptor boards have supplementary pin i[…]

Rpm Signal Dropout

With my 60-2 and VR sensor i don't use a capacitor[…]

just tell him to get it tuned properly. there is n[…]

Still can't find what you're looking for?