- Sun Feb 09, 2020 9:31 pm
Hi, I just got my speeduino Miata 1.6 pnp, which comes with a base tune (that started the car up right away no problem) but when I went into tuner studio to tell it about my specific sensors (wideband and air intake sensor) everything started to go wrong. I followed the step from wiki and everything was going great , it turn on my fuel pump and recognized that it was connected, allowed me to pick the gm air sensor but when I went to hit write it started "Reading controller settings again then went offline and an error popped up saying:
"Error reading data fromMIATA 2020 after 3 attempts
Error message returned:
Could not process CommInstruction.
Error written to log
Timeout after .3572ms. requested timeout:35725, Expected bytes:128, bytes read:80
Application will now go offline. To attempt going back online
check the Project menu when connection problems are resolved."
And if I leave it alone it will run the fuel pump again and the attempt count will go up. I closed turner studio and tried to start the car and now it will crank but won't fire!! Can anyone help fix whatever it is i screwed up???
Last edited by gradof6b on Sun Feb 09, 2020 11:59 pm, edited 1 time in total.