For any add-on boards such as VR conditioners, optos and OEM interface boards
#43754
Some more progress....
As i am too busy at the moment there is only slow progress for this controller.
The PCBs arrived from the manufacturer and all looks fine so far. I have flashed all of them and until here all looks fine.
Need to solder the CJ125 and the varistor on the PCBs and also need to do more detailed tests.
Stay tuned.
Attachments
IMG_20200615_130300.jpg
IMG_20200615_130300.jpg (837.42 KiB) Viewed 632 times
IMG_20200615_130232.jpg
IMG_20200615_130232.jpg (6.11 MiB) Viewed 632 times
#44043
chaoschris wrote:
Fri Jun 19, 2020 9:27 am
Some more progress....
As i am too busy at the moment there is only slow progress for this controller.
The PCBs arrived from the manufacturer and all looks fine so far. I have flashed all of them and until here all looks fine.
Need to solder the CJ125 and the varistor on the PCBs and also need to do more detailed tests.
Stay tuned.
how much for this?
#44278
Hello all

I throw in also my version of the wideband controller with cj125 and Arduino nano for LSU 4.9
It is a fresh thing, have not ordered the boards for published version yet. But I am quite confident that it should work as I have the thing working on earlier board and there was only some pin assignment changes. Also the firmware Arduino skech included. Currently calibrates and then displays Lambda value and sensor temperature in real time on LCD and outputs wideband lambda analog signal. Narrowband emulation not implemented at the moment.

https://github.com/TBAMax/speeduino/tre ... re/TeemoWB

Regards
Teemo
#44428
Hello all!
I am drawing my own BL49SP board on KiCad and i have few questions about the schematics:

1. "OUT" is 0-5v linear and "PWM" is simulated narrowband but what is the purpose of "IN" connector that go to PC2(ADC2) pin?
2. What state two leds represent, power and heating process?
3. I didnt find AO3400A from Mouser, would this be okay instead?: https://www.mouser.fi/ProductDetail/Inf ... S48UOXVw==

This is what the board looks like at the moment
Attachments
myBL49SP.png
myBL49SP.png (124.34 KiB) Viewed 279 times
  • 1
  • 10
  • 11
  • 12
  • 13
  • 14
proyect ford zetec-e 2.0 16v

Wow! Awesome. Thank you

I have moved my design files to the more logical p[…]

If you have max coil primary voltage at 400V : -[…]

Problems loosing sync

normally it should be ok, but the output from anot[…]

Still can't find what you're looking for?