[apollard]

Did you calibrate the sensors in TS? If not, you won’t get realistic readings - or perhaps none.

[leo_fischerlf]

i didn't , but at least should have a vary , shouldn't ?

[turboedge]

Nope probably not. Try the GM calibration to get you started. Program one, then switch drop-down at the top to the other sensor and program that one. You should see much better results.

[leo_fischerlf]

OMG how could i have been so dump !!!!!!!!!!!!!!

do you have the infos for me to fill up the table ?

[apollard]

You don't need the values for the GM sensors, just select them from the drop down box. Quite a few non-GM sensors use the same values, so it's a good place to start and will at least let you know the board is working.

If the temp values are off after you calibrate them in TS, you will need to find the correct values (or correct name in the drop down box).

[leo_fischerlf]

i see . but the 2k49 on the board is correct ?
can i calibrate whatever 2wire sensor i want ?

[apollard]

The 2k49 resistor is correct for most sensors. It might need to be changed for others.

What sensor are you using - part number and application?

[leo_fischerlf]

Iam using the MTE4053 for CLT and MTE5053 for IAT , they are used here on magnetti marelli AVB and AVP injection, at the VW , and some FIAT, if iam not mistaken they are the same as the GM corsa 1998 , but different enclosure

[apollard]

If the same as the corsa, the gm calibration and existing resustor should work.

[leo_fischerlf]

i just checked it , my CLT sensor at 23 Celsius degrees output 3.14k