Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For anything you'd like to see added to Speeduino
By andymcg
#24982
Has there been any progression on this? I am looking to use speeduino for my k series. is it possible to run using standard sensor and flywheel rather than fitting a 36-1 wheel? I have the 0.4.3 board with vr conditioner
By dazq
#24983
Not heard anything :-( perhaps you could put in another request on git for the feature!

i saw a video from the speeduino channel about bu[…]

Reset_Control

Very good to all, I am running a speeduino v0.4.3c[…]

In my case the clamp is behind the fuse so the[…]

Good afternoon, test the vvt map leaving off "[…]

Still can't find what you're looking for?