[Darren]

I have just built a NO2C, I'd like to clarify that the build is correct before plugging it in. I went off a couple of videos from the US, but then another video popped up:
https://www.youtube.com/watch?v=J_VEW6gqnHk&t=444s

This seems to have a different opinion on the resistor strip. Is there a true build video from someone like WTM showing correct polarity/direction for components and jumper settings. I've noted the reverse for the leds.
Just don't want to fry any components before powering up the ecu.
I have browsed github, but I may need to be pointed to a specific page
Cheers
Darren

[turboedge]

Hi Darren,

Have you seen these directions: https://wiki.speeduino.com/en/boards/3r ... embly_Tips

The jumpers are configured the same way that they are for an official 0.3 or 0.4 unit. With directions in the Speeduino wiki.

Weaver

[darreng]

Hi Turboedge,
Thanks for that, board all good, I'll plug it in today.