[PedroV9]

Hello folks, I made this design based on version 0.4.3d, it uses all the same components except for the Arduino, which here is a Mini PRO (obviously), and two outputs that in version 0.4.3d use DIP mosfets, and in this design, I used TO220.






https://www.pcbway.com/project/sharepro ... zfrD-gkDXA

Note: I have only performed tests on the workbench; I have not yet tested it in the car.

[toddTR6]

Looks Nice.

What are the dimensions of the board and what is the case you are using?

[dazq]

Looks Nice.

What are the dimensions of the board and what is the case you are using?

These case are available at AliExpress.
Some of the suppliers post the case dimensions on the listing.

[PedroV9]

I made some updates to the board, although the initial version has worked without problems in several vehicles.

changes:
-Jumper connections are now soldered pads;
-Added individual decoupling capacitors for Gate Drivers (TC4424);
-Added protection diode for 5v line;
-Added capacitor location for stepper motor driver (recommended in datasheet);

[PedroV9]

Hello everyone, the Gerber files are now available on GitHub:

https://github.com/ByRocha/PCB48VD-EFI-ByRocha/