For any discussion not specifically related to your project
By wink1212
#70479
Greetings, I was wondering if the speeduino supports 2 CAM sensors, I have a 350Z and was looking into building/buying a unit but couldn't confirm if It's supported. There are also 4 O2 sensors (2up and 2dn), does it support 2 widebands as well?

VQ35DE

Thanx
Wink
By Rednaxs60
#70480
Not at this time. Had the same issue with my Honda GW 1200 '85 FI Model. Two cam sensors for fuel injector firing.
By dazq
#70482
wink1212 wrote: Wed Jan 15, 2025 3:34 pm Greetings, I was wondering if the speeduino supports 2 CAM sensors, I have a 350Z and was looking into building/buying a unit but couldn't confirm if It's supported. There are also 4 O2 sensors (2up and 2dn), does it support 2 widebands as well?

VQ35DE

Thanx
Wink
The firmware does support two O2 sensors but the second input is only for logging and monitoring purposes it can operate any closed loop control.

The second cam input support is very limited and is still in its infancy so should be considered not for general use.
By stum
#70485
I am heading down a similar path.

I am converting a VQ35DE out of a Maxima (FWD 4 door)

My understanding is Speeduino does not have a trigger for the VQ crank/cam triggers. I have modified the flex plate to give me a 36-1 pattern. I have not tested it yet, as the gearbox has to come out again. And I still have to do some wring.

Good Luck
By wink1212
#70495
Thanx for all the input. I'm still in the pre-planning stages so I'm just tryna get as much info as possible.

Sounds like a 36-1 wheel. First step is to get an[…]

Have anyone done this? How could it be done? Thi[…]

I'm having fun in multiplayer mode! I can observe […]

Hello, I know this thread is little bit older, but[…]

Still can't find what you're looking for?