[1952IH]

I am testing my system (Proyect Berserker 2.0) after installation, and the fuel pump prime doesn't end. I have the cranking RPM set to 500, flood clear to 80%, fuel pump prime duration of 1, injector priming delay to 2, and the cranking enrichment to .5. I have not cranked the engine, just testing. The engine is an inline 6. I am using an electronic distributor as the trigger, and a 3 wire VW coil from a 1991 Golf. Can anyone tell me what I should I be looking at?

[LPG2CV]

How do you have the FP wired?

[1952IH]

I am using a relay. The ECU grounds the relay. I should add that the fuel injection portion is a GM TBI that I installed about 5 years ago, and it was working.

[jonbill]

Id be looking at whether you have the right board configured.

[LPG2CV]

Post your tune. And as @jonbill suggests, what board are you using?

[1952IH]

Tune attached. The board is a ECU Project Berserker 2.0.

Thank you for your help!

[LPG2CV]

I think you will need to go back to the supplier as they use there own version of the firmware and ini file. This is a version of Speeduino I am not familiar with.

Perhaps someone else can help?

[1952IH]

The supplier responded with "If there's noise pulses on the input, the fuel pump will keep running." So I guess look for noise? I don't have any relays being activated (ignition, injectors), and the engine is not running. I thought I had done a good job of wiring, but apparently not good enough.