[theonewithin]

How did you choose what pin is capable of being a ign/inj output?

There is a reason why the Mega2560 only does what it does...

[omidsadeghi]

Hi i am from iran. Icant buy the pcb filea. Are you can send it to me to build it
Tnx
My email is osadeghy@gmail.com

[theonewithin]

The files are freely available on GitHub.

Not need to buy anything.

[omidsadeghi]

Where i can find the altim files of speeduino pcb
The pcb maker company just allow the altium files

[dazq]

Where i can find the altim files of speeduino pcb
The pcb maker company just allow the altium files

The V3 boards were designed in Fritzing as were all early boards.
I haven't heard of anyone using altium, most use kicad or eagle
You may have to redraw it if that's the only one you can use.

[La Team Prep]

Hello everyone, nice being here!

I have an issue I think some of us have had experienced at least once.
IAT and CLT inputs, NOT WORKING. I have gone through my schematics thoroughly, went back to the manual over and over and yet sill something is off!

According to the V 0.3 & V0.4 series IAT and CLT are respectively connected to A0 and A1 and yet still not working.
So here is my question, is there a config file that need to be edited, since the sensors + the pulling up 2,49k resistor act literally like a potentiometer it should work, everything else do!

My board is custom and i stick to the pin charts, I am good at electronics an KiCad but not that much in coding so maybe I have missed something. Any info would be highly appreciated! Thanks in advance.

[jonbill]

Which board do you have selected in engine constants, and have you calibrated the sensors in TS?

[La Team Prep]

Which board do you have selected in engine constants, and have you calibrated the sensors in TS?

Thanks for your response, I have found the issue. My Tuner Studio was stuck on "Select a common sensor". I had to install the update then everything was working flawlessly.