[Cgrant]

Hi,
I have an open source PDM (power distribution module) project that I would like to share.
It's a work in progress, but software/firmware functionality is being added every week.
https://corygrant.github.io/dingoPDM/

I do offer pre-built units as well: https://dingo-electronics.square.site/

Discord
https://discord.com/invite/jEgeMZja

[PSIG]

Looks nice! The Profet has a lot of potential, and I look forward to seeing where you've gone with this. Silly question, I like the case appearance, so what did you use to print it?

[digmorepaka]

Looks awesome! Big thumbs up for the DT connector from me!

[stum]

Looks great. and is priced well too. Good work

Just a thought, in some installations it would be nice to have 4 inputs and no CAN. could this be done via configuration??

[Cgrant]

Looks nice! The Profet has a lot of potential, and I look forward to seeing where you've gone with this. Silly question, I like the case appearance, so what did you use to print it?

That's nylon SLS from JLC. I've been really happy with the quality.
I get MJF parts from them at work frequently and they look just as good.

[Cgrant]

Looks great. and is priced well too. Good work

Just a thought, in some installations it would be nice to have 4 inputs and no CAN. could this be done via configuration??

It would be a bit difficult with this design.
The CAN transceiver could be removed and some jumpers added but that would be raw inputs to the MCU.
The other inputs have protections built in.

If it's a switch or something they could easily be added with my CANBoard.
https://dingo-electronics.square.site/p ... MQCETH7XZB

[stum]

I didn't see that board. Nice solution. Over comes the need for my comment above. Cheers