Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
By Bodie
#68458
Hi all,

Just converted an engine to speeduino to control fuel only. The engine has a VR output that sends a pulse every 360 degrees on the crank. I've used "basic distributor" to get the engine running, however the tuner studio rpm is half of the actual engine rpm.

I've been scrounging through the speeduino code trying to find where I could change the decoder to simply double the sensed rpm.

Any ideas?
User avatar
By digmorepaka
#68465
Bodie wrote: Sat May 25, 2024 11:17 am Hi all,

Just converted an engine to speeduino to control fuel only. The engine has a VR output that sends a pulse every 360 degrees on the crank. I've used "basic distributor" to get the engine running, however the tuner studio rpm is half of the actual engine rpm.

I've been scrounging through the speeduino code trying to find where I could change the decoder to simply double the sensed rpm.

Any ideas?
Basic distributor on 4 stroke assumes that the signal is cam speed, you can work around it by setting double the cylinders, single injector, and half the required fuel.


You could also set it to 2 stroke I guess, basic distributor pattern there runs on crank speed.

NP, and we have to start with the simple stuff. A[…]

Of course, I will likely seize a cylinder and inc[…]

speeduino injector

What is the maximun resistance for nozzles is 14[…]

Hi all, i'm from Brasil, here is very dificult t[…]

Still can't find what you're looking for?