Help with building your Speeduino, installing it, getting it to run etc.
By Antho917
#67251
Good morning.
I installed a speeduino on my clio 2 rs. with an STM32 controller by pazi88.

but the can bus does not want to work.
I tested with a universal diagnostic tool and an ELM327 but no information was transmitted to my obd2 port.

I don't know if this is due to an error on my part, a bad setting in tunerstudio or a hardware default.

if anyone has any idea what my problem is.

THANKS.


ps: sorry if my English is bad, I am French
By Antho917
#67256
I placed a 120 ohm resistor on the speeduino side between the Can H and Can L wires.

On the OBD2 port I measured the resistance between the Can H and Can L pin. I have 60 ohm like the original system

No worries. Life gets in the way. A lot. See yo[…]

STM32 development

So here's a little update on the subject of my pas[…]

NO2C crank signal issues

Also sometimes when i turn the ECU off it seems to[…]

I don't think there can be another cause - it'll b[…]

Still can't find what you're looking for?