Help with building your Speeduino, installing it, getting it to run etc.
By MGR550
#67461
Figured out the fuel pump issue, was bad crimp on the wiring on my part.
For the trigger wheel, I hadn't actually ever counted the reduction from crank to distributor housing shafts; turns out it is 2:1, so I cut 1 more tooth off my 36-1 trigger wheel and made it into sortof a pair of 18-1 wheels which seems to work well in the tooth logger.
Got the wiring onto the bike nicely, intake adapter and throttle body on and a temporary fuel feed hooked up and managed to fire it up!
Was giving a few puffs out the exhaust and a few coughs/prefire out the throttle body during cranking, but once it fired up it seemed to hold idle for the 2 or 3 seconds it was on for before I shut it off.
What should I be looking for in the log file at this point for debugging and starting off? Only focus on idle-related settings until its idling proper? So many things to check and tune I'm not sure where to start.
Attachments
(81.78 KiB) Downloaded 7 times

Bro, just put speed to take care of all fuel and i[…]

No worries. Life gets in the way. A lot. See yo[…]

STM32 development

So here's a little update on the subject of my pas[…]

NO2C crank signal issues

Also sometimes when i turn the ECU off it seems to[…]

Still can't find what you're looking for?