Any general discussion around the firmware, what is does, how it does it etc.
#67183
Your install has to live in the real world as Jholland says, not your garage. I know microaquirt does it. What hasn't been discussed is what fault detection/ tolerance is built in or what problems users have.

OEMs have been on a quest to save half a penny forever. How many have eliminated the costly cam sensor for the microsquirt scheme? They have to warranty those engines and so far I haven't found one.

Don't misunderstand, it intrigues me and I hope it works. My experience is that it will need some fault tolerance. Even on a track, the guy with the super ignition system his BIL installed will created lots of EMF. Your install, no matter how well done includes lots of wires that act as antennas tuned to various frequencies.

Hello I have a ua4c board and I just finished tuni[…]

If you want the simplest/easiest setup then you c[…]

Tach output and RPM sensor issues

Hi, I am in the process of converting the ignition[…]

BMW E23 M30B28

I'll figure out the tach eventually, but now there[…]

Still can't find what you're looking for?