[SpotTheDogg]

Hi everyone, I am feeling a mix of confident in my plans and out of my comfort zone in the execution of said plans.
I am converting my 1990 Honda VTR250 race bike to EFI with a NO2C VD1 and am in the adding firmware phase. I am trying to understand where a base tune is for the NO2C board... When I installed the firmware on the Mega 2560 I used the stock base tune for 202310 and I am pretty sure it was wrong because it said for V0.4 board.

Thanks for any input

[LPG2CV]

The board selection is a drop down list

[PSIG]

PCB selection in TS.jpg (99.12 KiB) Viewed 1922 times

[JHolland]

Off topic but a VT250F was my first race bike back in 1985.

https://www.facebook.com/bkvpsport/vide ... 093882760/

I don't think that I was in that race though.

[SpotTheDogg]

Thanks folks, I will dig more on the setup over the weekend. It was when I was first setting up the connection that I didn’t see NO2C in the available boards list.

[SpotTheDogg]

The board selection is a drop down list

Yes, but the list only seemed to have the Stock Base tune I listed in my question and a bunch of MX5/Miata ones. This was at the point I was putting firmware on the Arduino with Speedy loader

[LPG2CV]

So reading through the topic again, you have sorted out the board selection. Regarding the tune, there are only a Base and MX5 tunes available. You don't load a dedicated tune for a board, you need to use the base tune, configure it, and then tune it. The base tune is just there to get you stared.

Don't forget to calibrate the sensors.

[SpotTheDogg]

Yes, thank you. I’ve gone back in to Tuner Studio and put in some of the values I know in Engine Constants and set board to NO2C. The bike is in pieces, including the engine, so I won’t be doing much more for a little while. I feel more comfortable with my understanding so far, thanks again.

[SpotTheDogg]

My next issue is to do with pairing Bluetooth, it will pair with the laptop but my Android tablet doesn’t even see it. Neither do my Apple devices for that matter

[SpotTheDogg]

Should I be able to pair an Android tablet when plugged into my laptop or will it need to be hooked up to independent power?