[HandCrank]

New to speeduino and maybe I'm missing something. On the 4.3c boards there was the proto area for adding additional sensors. Is there a way to add sensors like oil pressure to the 4.3d? I cannot find any information for the newer board.

Thanks

[HandCrank]

After looking at the hardware schematics I was able to poach 5v from J1 and utilize A9 (j5) for oil pressure. I did have to re-label the pin and set parameters in tunerstudio. I would be able to do the same for fuel pressure on A10 as they are the same setup as all the other inputs. I did configure A10 for fuel level under a custom pin setup. I will spend more time on the settings as it has no set parameters at the moment.

[PSIG]

Perhaps someone here has better links for AUX channel setup, but the one I found was here: viewtopic.php?t=2809 The images were remotely posted and missing. I thought it was a 2-part post, but can't find it (or the right one). The EFIAnalytics (TunerStudio) page is here, and is of course generalized, using another system for the example: https://www.tunerstudio.com/index.php/p ... nel-wizard

I have not viewed them for content or applicability, but these two videos were also referenced:
https://www.youtube.com/watch?v=qik-HqftuWQ
https://www.youtube.com/watch?v=CZmskglysMM

I'm hoping the concepts, bits and pieces of all that is helpful and not just confusing. A re-do of the @ESDave posts could be produced for the Wiki or a sticky?