Any general discussion around the firmware, what is does, how it does it etc.
#65098
Hello, As part of developing the K20 decoder I've improved the D17 decoder and added support for the 4+1 cam. This means you can now do sequential and VVC(Vtec).

If anyone wants to test this please send me a private message. Ideally I'd like you to have a running car so we're fault finding the new code and not the tune / wiring / config of the car.

(If you're reading this message in a few months time, please check the wiki in case the development has been completed - https://wiki.speeduino.com/en/decoders/Honda_D17).

Cheers Mike
Can bus problem with STM32

I placed a 120 ohm resistor on the speeduino side […]

How bad did I mess up my PCB

It's probably recoverable. Take a look at the sche[…]

Suzuki RE-5 EFI Conversion

check the relay is clicking, and the fuse. Check t[…]

That’s awesome! Congrats! So you were still[…]

Still can't find what you're looking for?