- Thu Aug 17, 2023 2:18 pm
#64448
Hi there! im learning hard about this and even when trying to find info, many times i even had more questions and it's difficult that someone can help and still lucky that some forums are still alive! i hope you can give me any kinda input about this!.
Im thinkin in to add as external input, another temperature sensor, similar than IAT and CLT sensors. Shematics i guess could be similar to IAT/CLT, my question is about how does it can be configure in TS? i havent idea about programming, so i assume by editing .ini could be this done, i guess.. but does it is possible to configure it , let say , in Custom channel Editor? my question is about how do i can do exactly? using same shematic than IAT/CLT , of course different MCU pin and of course it clamped, how dont know how add BIAS resistor value and resistor - ohm values. i know the other way is just to do a voltage divider then add is a 0-5v input but , could be possible to do what im asking? thanks in advance!
Im thinkin in to add as external input, another temperature sensor, similar than IAT and CLT sensors. Shematics i guess could be similar to IAT/CLT, my question is about how does it can be configure in TS? i havent idea about programming, so i assume by editing .ini could be this done, i guess.. but does it is possible to configure it , let say , in Custom channel Editor? my question is about how do i can do exactly? using same shematic than IAT/CLT , of course different MCU pin and of course it clamped, how dont know how add BIAS resistor value and resistor - ohm values. i know the other way is just to do a voltage divider then add is a 0-5v input but , could be possible to do what im asking? thanks in advance!