Tune changes with laptop disconnected

Any strange behaviour, crashing issues etc, post them here! Problems compiling the firmware should go in the General support section rather than here
 Reply

Re: Tune changes with laptop disconnected

By Jyri
-  Thu Jul 13, 2023 7:13 pm #63994
Was there any update to this? I am facing the same problem (0.4.4c + MEGA2560) when I adjust the ve table and disconnect tuner studio the car leans up quite a lot (from about 14-15 to 16-17) this is annoying and makes tuning impossible. I also tried to update to the latest fw today to no avail.
Thanks in advance if anyone has a solution.
 Reply
 Return to “Bugs / Issues”
4 Cylinder 250 motorbikes - planning stages

Hi there, I'm doing preliminary research and hope[…]

READ MORE
BMW E23 M30B28

Where did the plugs come from? I've heard there ar[…]

READ MORE
Injected 2 stroke Bultaco

Alternator testing. Its a 3 phase circa 200w alter[…]

READ MORE
NO2C crank signal issues

Once again PSIG, thank you. Note this is set up fo[…]

READ MORE
VIEW MORE TOPICS

Still can't find what you're looking for?

Try the Wiki!