Any general discussion around the firmware, what is does, how it does it etc.
User avatar
By Spidii
#63275
I have doubts about it, I program 8000 rpm for the tachometer sweep, but it only reaches 7000. From what I see, the process lasts approximately 1.5 seconds and I suppose that my tachometer is not fast enough. Any solution?
Thanks
User avatar
By Caeden Chong
#63280
I had change the TACHO_SWEEP_TIME_MS default value from 1500 to 4000 and the RPM sweep able to reach 9000rpm and sweep very nice.

Very happy with this new feature in my old junk.
Attachments
Screenshot 2023-05-30 212909.png
Screenshot 2023-05-30 212909.png (22.77 KiB) Viewed 7192 times
By miker
#63281
The feature was added as a joke originally, but then it took on a life of its own and got implemented.

In the spirit of the source of the feature, reduce your redline to 7000 rpm πŸ˜‚
User avatar
By Spidii
#63406
Caeden Chong wrote: ↑Tue May 30, 2023 1:32 pm I had change the TACHO_SWEEP_TIME_MS default value from 1500 to 4000 and the RPM sweep able to reach 9000rpm and sweep very nice.

Very happy with this new feature in my old junk.
Thanks !!!
User avatar
By Spidii
#63407
miker wrote: ↑Tue May 30, 2023 1:49 pm The feature was added as a joke originally, but then it took on a life of its own and got implemented.

In the spirit of the source of the feature, reduce your redline to 7000 rpm πŸ˜‚
the small engine of the 205 rallye works well up to 7500 rpm, the tach goes to 8000 so I would like to do the full sweep
By Eddie78
#63470
My tacho goes to 8k but was only sweeping to 7kish, instead of changing codes etc.... i just played about with the rpm i ended up setting it to 8700 rpm for the sweep and now my gauge sweeps all the way to 8k.
By Slydit
#63895
Which pin does tach sweep work on?
My Miata gets its tach signal from the ignitor not the "tach" pin...I'm assuming tach sweep won't work?
blitzbox

Me too. I got the bootloader on there with succ[…]

Maybe try in english.....

J35a4 Triggers

Hello, Working on J35A4. Would like to have/con[…]

Torque reduction request for AT

I probably have burnt Arduino pin 51,I changed the[…]

Still can't find what you're looking for?