Dual idle actuators on 2011 BMW R1200RT 1150cc (Camhead)

Dual idle actuators on 2011 BMW R1200RT 1150cc (Camhead)#62774

By Marvin2Shoes - Mon May 01, 2023 9:10 pm

- Mon May 01, 2023 9:10 pm #62774

Hi all, I have an idle actuator on each of my 2 cylinders.... the idle actuator is the motor with 4 wires connected to it in the attached photo.
Apparently the NO2C board only supports operation of a single stepper controller in firmware/on board. Has anyone any idea if I can use an as-yet-unprogrammed output on the NO2C board to control a second stepper controller, with required changes to firmware code to add functionality?

20230502_065729.jpg (3.6 MiB) Viewed 1343 times

Re: Dual idle actuators on 2011 BMW R1200RT 1150cc (Camhead)#62776

By dazq - Mon May 01, 2023 11:26 pm

- Mon May 01, 2023 11:26 pm #62776

I just posted a reply on your main thread, simple answer , no not without a LOT of new code written in.

Quantum Coupe with V04 on Ford 1.4CVH,Quantum 2+2 with Custom V04 on Jaguar 3.0l AJ30 V6
mini GPIO :done More soon
CANbus broadcast interface: done
Simple sd logger :done
External CAN io: Inputs :done
Gearbox controller: working

Re: Dual idle actuators on 2011 BMW R1200RT 1150cc (Camhead)#62778

By Marvin2Shoes - Tue May 02, 2023 3:22 am

- Tue May 02, 2023 3:22 am #62778

dazq wrote: ↑Mon May 01, 2023 11:26 pm No not without a LOT of new code written in.

Thanks dazza