For any discussion not specifically related to your project
#62224
jonbill wrote: Sat Apr 01, 2023 6:20 pm If those odd programmable outputs have appeared on their own, I'd run an eeprom-clear before reloading the tune.
Re piston holes: I mean mechanical failures happen when they happen, and with a new built engine I'd be thinking about that too.
If eeprom-clear and reloading the tune dont fix it, I'd compression test all 4.
okay, can u explain how i would do that?
#62227
jonbill wrote: Sat Apr 01, 2023 6:50 pm Eeprom-clear? Its a "firmware" you can download and install with speedyloader. It zeros out all the eeprom.
It runs when the mega boots, so after you've loaded it and rebooted the mega, reload the firmware and your tune.

Okay thank you very much. I hope this will fix it :)

maybe, why? I'm sure the github docs are correct. […]

STM32 development

I can certainly build and upload master, which I d[…]

4age 16v smallport

Just an update on where this went as i hope this h[…]

Weird is correct. saw your post and understand. […]

Still can't find what you're looking for?