[Tommyboyblitz]

Hi i am looking to set this up on 2 different engines a 1JZ and a 1G engine both use primary and secondary trigger wheels, Primary is 36 with 2 missing teeth and the 1JZ has a 3 tooth cam signal to start the sequence for the 2 revolutions. The 1G has a similar setup.

I have looked at the dual wheel and the single wheel and cant seem to enable primary with missing teeth with a secondary cam signal?

Cheers

[noisymime]

You want to use the missing tooth pattern, set as 36-2. In your case you don't actually need the cam signal at all as there's not sequential support for 6 cylinders anyway. The 36-2 will be all you need for a semi-sequential setup

[Tommyboyblitz]

Oh yea your right there, Thats all good then. Thanks mate

[lilycollins]

Considering that there is no sequential support for 6 cylinders, bitlife you actually don't need the cam signal.

[miker]

Appreciate its not relevant for this specific instance but for reference, i've developed and got someone testing the toyota 3 pin cam on the v8 engine (and 2 pin exhaust cam).

I've also added code to (hopefully) support the 4 cylinder engine.

[PSIG]

The previous post by @lilycollins has been reported, as not only SPAM, but also that it is wrong.

[bernhardjamil]

Recognizing that it isn't pertinent in this case, I did create and had someone test a Toyota 3 pin cam for a v8 engine (and 2 pin exhaust cam).

To possibly support the 4 cylinder engine, I've also included code.
basketball stars