[Welp]

Hello Everyone,

Does anybody know how to test for injector open time? Because, I've seen megasquirt users done this getting their injector open time.

Thank you.

[PSIG]

Do some searching for previous info and examples of bench-testing with an oscilloscope or by timed pulses vs flow volume; or run-testing on the engine using either manual O2 correction or by calculation, etc. Injector latency is important at low PW, and a common source of tuning frustration, so pick your method and go for it. You can also find various articles online for ways to get a good set of numbers for latency (dead-time, lag, open-time, etc).

[Welp]

PSIG you're a freaking GOAT when it comes to Speeduino. I never had the chance to thank you enough. So, Thank you for being an active member of this forum and also being so Freaking smart!