Speeduino is now on Github Sponsors (Rather than Patreon): https://github.com/sponsors/noisymime
For any discussion not specifically related to your project
#58107
Hello Guys,

I have a project and it is only a single cylinder but I want it to be staged injection and it will be Full sequential injection. How do I wire it up? Because it says on the manual (Primary injectors on outputs 1 and 2. The secondary on outputs 3 and 4.) But in Full sequential it occupies the 4 pins. So, is it still the same? or not.

https://speeduino.com/forum/download/fi ... w&id=10102
Attachments
298524926_625663198869993_3766129523301682232_n.png
298524926_625663198869993_3766129523301682232_n.png (85.54 KiB) Viewed 743 times
#58115
you can get (in principle, at least) speeduino hardware that supports 8 injectors, the problem is there's only one Speeduino software and it says that 4 cylinder staged is not sequential. I'm sure it wouldn't be so hard change, but someone would have to do it.
#58117
jonbill wrote:
Sat Aug 13, 2022 8:57 am
for a single cylinder engine, channel 1 is the primary injector and channel 3 is the secondary.
This. Some background on your project requirements would help with better replies. IIRC staged secondary is simultaneous with the primary, so no issues there, though by the time you're into the secondaries sequential is effectively irrelevant, and the primary purpose of sequential (cylinder trims) is also irrelevant. For a 1-cylinder, the only addition is the cycle sensor signal to set "sequential", which is only the cycle ID for a 1-banger. Depending on your project requirements, an alternative is quasi-sequential, injecting every 360°, and used by several car makers today for economy and performance as it dwells more of the fuel for increased vaporization over standard sequential. No cycle signal required.

For the staged part, any ECM version of 2-ch or more should be fine for a single-cylinder. 4-ch will work out-of-the-box. If I have this right in my head (it's been a couple years since I've done staged), a 2-ch will need to have the second INJ channel reassigned output as INJ3 to function with standard code for staged. That's easy, though any code updates will require re-configuring the channel again. I would bench-test it to verify everything is working as-expected, then run it. 8-)
WBO2 controller with LSU ADV

I also bought it. It does what it's supposed to. T[…]

Welcome! Read the Wiki lightly, just to get overa[…]

Couple of sites you could try for the connector: C[…]

Nissan CAS timing

Thanks for your help. Once I get everything in I a[…]

Still can't find what you're looking for?