[speeduino-v6]

Hello, Im tryring to get a v6 60Degrees engine ignition to run on a speeduino 0.3.7. But im not getting any spark of my wasted spark coil. When i am testing te outputs of the speeduino it give 5Vdc and the wasted sparkt coil fire by turning the 5V off. Im using
only the original distributor with a 6-1 wheel that gives a 12v puls on rpm1 . When cranking the rpm goes up in tunerstudio.
The engine fuels is regulated with an carburator.

Wasted spark coil
Febi 078 905 104 a
jumper setting
jp1 5v
jp2 vr conditioner
jp3 vr conditioner
jp4 off
jp5 off

[neovin]

looks like you didn't load a base tune before you configures your project

Speeduino base tune.msq

(84.85 KiB) Downloaded 51 times

load this and reconfigure your engine constants and trigger settings