pazi88 wrote: ↑
Thu Jul 29, 2021 6:29 pm
marogarage wrote: ↑
Thu Jul 29, 2021 2:31 pm
I connected it as you said and still no RPM signal. I set semi-sequentional injector layout in TS and trigger settings from Pazi88's base map. Is that correct if i have 3.2V at VR1+ when i plug in sensor? Maybe my sensor is damaged? And should i plug off cam sensor when it's not needed?
Did you see the instructions on the GitHub:
Using hall type sensors instead of stock vr:
JP23 and JP24 are used to power optional hall sensors with 5v or 12v. Do not use these with VR conditioner!
In rev 1.x the power will be sent to pin2 in the sensor connector. Pin 1 will be signal and pin 3 is ground.
In rev 2.x the power will be sent to pin1 in the sensor connector. Pin 2 will be signal and pin 3 is ground.
If sensors require pull-up resistor, the R39 is used for that for crank and R40 is for cam.
In addition to that R59 and R60 need to be added to get the signal to processor when VR-conditioner is not used and
you need to jumper 2-3 in JP31.
Yes, i saw. My jumper config is: JP24 5v, JP31 2-3. And i have R59 and R39 too. This part: "In rev 2.x the power will be sent to pin1 in the sensor connector. Pin 2 will be signal and pin 3 is ground." isn't clear for me. My sensor haven't written any numbers at connector. How should i know what pin is 1,2,3? I used this diagram during connection: (white gnd, black +5V, red sign)