Don't know. Sometimes gerbers from EasyEda do that. But even thought the preview doesn't work, the PCB's will come out fine. Just add the dimensions (118*155) by hand if it doesn't recognize it.
No code changes needed. It should work without any changes (if VSS is wired in the car), although I haven't verified it. VSS input pin is D3 and at least in upcoming FW release, you should be able to use default input pin. The VSS signal should come out of ABS unit also in case of fault.
I'm curious for the spec's here as well. Diesel[…]
You may find it interesting, that most racing te[…]
Whatever gets you what you're after. This is one […]
Thanks a lot for the info! I have read some on the[…]