Molex ECU Connector Query

Molex ECU Connector Query#50340

By Devinder Singh - Sat May 15, 2021 9:32 am

- Sat May 15, 2021 9:32 am #50340

I am planning to use this Molex 560045-1201 CMX connector for my ECU design. Is it possible to wire it on a double layer PCB? I have also attached the datasheet. The pitch is 2.5mm for signal pins which makes it difficult to route the tracks upto connector pins as they are tightly packed.

Attachments

IMG_20210515_144249.jpg (6.06 MiB) Viewed 11262 times

IMG_20210515_144258.jpg (5.6 MiB) Viewed 11262 times

IMG_20210515_144308.jpg (5.21 MiB) Viewed 11262 times

5600451201_sd-1875009.pdf

(523.29 KiB) Downloaded 785 times

Re: Molex ECU Connector Query#50445

By SilentBob - Thu May 20, 2021 1:08 pm

- Thu May 20, 2021 1:08 pm #50445

What mcu are you using? 120 pins is probably way more than you'll need. Maybe look for a connector with a lower pin count and wider spacing if it's a concern