So I was looking at the code for the 6 cyl Jeep 2000 decoder.... it doesnt look too difficult to change the tooth count and the degrees and the degree between the clusters of notches to adapt to the 2.5 4 cyl version.
if I wanted to do this myself, to test, i feel pretty comfortable trying it. any thoughts? any procedures to contributing to the codebase?
that said, im not sure how to deal with the single rising and falling edge of the distributor. is this part defined in tunerstudio?
I guess ill have to flash my ecu with the 6 banger jeep 2000 and then look around. then ill look into modifying the values for jeep2000 and see if it works.
reliant_turbo wrote: ↑
Thu May 27, 2021 2:21 pm
Has the Jeep 2.5 Crank/Distributor been added? I know the 6 cyl "Jeep 2000" version has been but I havent seen the 2.5L 4 cyl version as shown in the attached image.
I want to use Speeduino on my 97 Wrangler with the 2.5 for a turbo project without having to add a crank wheel and/or modify the distributor.